You will need:

• 6mm Allan Wrench [ socket wrench type ] 
• 15mm socket [ deep ] 

**REMOVAL**

• Remove the [2] 6mm allan bolts that retain the top muffler.
• Loosen the 15mm nut on the top muffler clamp.
• "Wiggle" the top muffler off [ carefull not to strike swing arm] 

   NOTE : If the muffler will not budge! You can pry between the clamp bolt and the welded area of the center section. Gently pry while wiggling the muffler.

•  Remove the 6mm allan from the bottom of the lower muffler
• Loosen the 15mm lower muffler clamp.
• Wiggle muffler off

 **INSTALL**

• Aply a little "ANTI-SEEZE" or Grease to the inside of the clamp flange
• slide lower muffler and clamp onto bike [ do not tighten ]
• Install upper muffler and clamp [ do not tighten ]
• Install the [2] upper allan bolts. you may have to work the upper and lower mufflers to get the holes to line up.
• Install the lower 6mm allan bolt and tighten.
• Tighten the [2] upper allan bolts.
• Align and tighten the [2] 15mm clamp nuts.